Skip to main content

CONCLUSIONS

Conclusion 

The TIME, DATE, and VER commands are easy to use and understand. These are typical of most DOS commands. The command lines contained in the CONFIG.SYS and AUTOEXEC.BAT files, though more complex, are commonly used. More information is provided about the command lines found in the CONFIG.SYS file later in this blog. The effect of the command lines contained in the AUTOEXEC.BAT file are all described in detail, with supporting learning activities.
Labels:

Comments

Post a Comment

Popular posts from this blog

MEM

MEM The MEM command was introduced in DOS version 4.01 and memory information. The MEM command is entered alone or with a modified slightly in MS-DOS 5.00. MEM is used to display system memory information. The MEM command is entered alone or with a parameter. MEM-Displays to all system memory values, including expanded and extended memory values. MEM PROGRAM--Displays programs presently loaded in memory with used and unused memory. You may use /P if you are using DOS 5.00 MEM/DEBUG--Dispiays a list of programs, device drivers, install drivers, and used unused memory. You may use / if you are using DOS 5.00. MEM CLASSIFY (or MEM /C)-Displays programs and cor-responding memory usage. The largest available memory block is also displayed. You may use /C if you are using DOS 5.00. Typing MEM and pressing Enter displays information similar to the following (typical of DOS 5.00): C:\>MEM                   655350 bytes total conventional memory        
Post a Comment
Read more

Filenames

It is important to understand DOS file naming conventions and their use. Here, filenames and some special filename "tools" called wild cards and literals are described. What is a File name?   Every program and data file is given a name to differentiate it from other programs and data files. A program is one or more computer instructions collected into a file. A data file is normally a collection of characters (or data) that make up a document, like a letter, or a database, like a collection of accounting transactions or customer records. Descriptive filenames are normally used. For example, if you create and save a letter to Mom, you might give it the filename MOM.LTR. A letter to Dad could be called DAD.LTR. A word processing program file might have the filename WP.COM. Examine these filenames a little closer. First, notice that each filename is meaningful. This is important if you want to know what is in a file by looking at its name. Obscure filenames are of little u
Post a Comment
Read more

Disk Construction

The various parts of standard 5.25- and 3.5-inch disks are contained in Figure 1-2. A description of each part is also provided. Write protect notch--When covered, prevents information from being recorded on the disk; when uncovered, information can be recorded. Temporary label--An adhesive-backed label allowing the contents of a disk to be identified. Permanent label--When used, contains disk manufacturer and capacity information. Exposed recording surface--Metal oxide surface used to magnetically record data. Do not touch! Protective jacket --House magnetic disk; provides protective cover. Disk sleeve (envelope)--Used to store disks;prevents  accidental contact with exposed surface. Protective slide --Protects magnetic media surface; slides open when inserted into a diskette drive (only on 3 1/2-inch diskettes). Figure 1-2 The Parts of a Floppy Disk Construction : Almost everyone is familiar with audio recording tape. The tape is a long, flexible acetate or mylar strip coated with fe
Post a Comment
Read more