Skip to main content

Restarting With Ctrl-Alt-Del

Restarting With Ctrl-Alt-Del


Pressing the Ctrl, Alt, and Del keys simultaneously restarts your computer system. This process is called warm boot, reset, or reinitialization. If your computer "hangs" (or crashes) for some reason, it may be necessary to reset with Ctrl-Alt-Del to get it going again. You should do this only as a last resort. If the Ctrl-Alt-Del key sequence has no effect, it means that the codes are being send from your keyboard are no longer being received and interpreted by your computer. If this happens, you must turn the power off, wait several seconds, and turn the power back on again to resume operation. If you have a fixed disk, you should wait until disk rotation stops before turning your computer back on.


Labels:

Comments

Post a Comment

Popular posts from this blog

MEM

MEM The MEM command was introduced in DOS version 4.01 and memory information. The MEM command is entered alone or with a modified slightly in MS-DOS 5.00. MEM is used to display system memory information. The MEM command is entered alone or with a parameter. MEM-Displays to all system memory values, including expanded and extended memory values. MEM PROGRAM--Displays programs presently loaded in memory with used and unused memory. You may use /P if you are using DOS 5.00 MEM/DEBUG--Dispiays a list of programs, device drivers, install drivers, and used unused memory. You may use / if you are using DOS 5.00. MEM CLASSIFY (or MEM /C)-Displays programs and cor-responding memory usage. The largest available memory block is also displayed. You may use /C if you are using DOS 5.00. Typing MEM and pressing Enter displays information similar to the following (typical of DOS 5.00): C:\>MEM                  ...
Post a Comment
Read more

DOS CONFIGURATION AND AUTOMATIC EXECUTION FILES

The CONFIG.SYS and AUTOEXEC.BAT files can be used to set the way your computer responds to commands. The purpose of each of these files is briefly described. Although these files are not always essential to the proper operation of your computer, there are certain programs that depend on their presence. At this point in your exploration of DOS, you are not expected to make use of these commands. However, it is important to know what they are and how they can be used. When you finish this blog, you may wish to experiment with the effect of these files on the way your computer interacts with certain programs, its operating speed, and the allocation of memory. CONFIG.SYS When your computer is turned on, DOS  checks for a CONFIG.SYS file and adjusts your computor's configuration according to commands contained in that file. The CONFIG.SYS file is always found on the main directory of the DOS book disk. If you have a hard disk system, it is found on drive C, although you can boot from ...
Post a Comment
Read more